MODEL 51240B/53540B/53640B/61240B/63540B/63640B
9
Before installation, read all those instructions completely. Then obtain
all materials and tools needed for installation.
The installation of product, pipes and circuits, should be accomplished
by professional to ensure the product can operate normally.
Perform installation according to the relative pipeline regulations and
the specification of Water Inlet, Water Outlet, Drain, and Brine Line
Connector.
B. Device location
① The filter or softener should be located close to drain.
② Ensure the unit is installed in enough space for operating and
maintenance.
③ Brine tank need to be close to softener.
④ The unit should be kept away the heater, and not be exposed outdoor.
Sunshine or rain will cause the system damage.
⑤ Please avoid to install the system in one Acid/Alkaline, Magnetic or
strong vibration circumstance, because above factors will cause the
system disorder.
⑥ Do not install the filter or softener, drain pipeline in circumstance which
temperature may drop below 5℃, or above 45℃.
⑦ One place is recommended to install the system which causes the
minimum loss in case of water leaking.
C. Support installation
Take out 8 pieces of support and door mats, and install them according
to the Figure 1-1. (The parts description please refers to 5040009 support
structure on page 50.)
To Next Page
Loading...
Need help?
General
