MODEL 53540B-F112B1/53640B-F112B3/63540B-F112A1/63640B-F112A3
1
Notice
To ensure normal operation of the valve, please consult with professional
installation or repairing personnel before use it.
If there are any of pipeline engineering and electric works, there must be
finished by professional at the time of installation.
Do not use the control valve with the water that is unsafe or unknown
quality.
Depending on the changing of working environment and water
requirement, each parameter of softener should be adjusted accordingly.
When the water treatment capacity is too low, please check the resin. If
the reason is shortage of resin, please add; if the resin is turn to reddish
brown or broken, please replace.
Test water periodically to verify that system is performing satisfactorily.
Ensure that there is solid salt all the time in the brine tank in the course of
using, when this valve is used for softening. The brine tank should be
added the clean water softening salts only, at least 99.5% pure, forbidding
use the small salt.
Do not put the valve near the hot resource, high humidity, corrosive,
intense magnetic field or intense librations environment. And do not leave it
outside.
Forbidden to carry the injector body. Avoid using injector body as support
to carry the system.
Forbidden to use the brine tube or other connectors as support to carry
the system.
Please use this product under the water temperature between 5～50℃,
water pressure 0.2～0.6MPa. Failure to use this product under such
conditions voids the warranty.
If the water pressure exceeds 0.6Mpa, a pressure reducing valve must
To Next Page
Loading...
Need help?
General
