MODEL：F56A/F56B/F56C/N56D/F56E/F56F/F56AC/F56EC
8
Note:
●The length of riser tube should be neither higher 2mm nor lower 5mm
tank top opening height, and its top end should be rounded to avoid
damage of O-ring inside the valve.
●Avoid floccules substance together with resin to fill in the tank.
●Avoid O-ring inside control valve falling out while rotating it on the tank
Pipeline connection
a. As Figure1-2 shows, install a pressure gauge in water inlet.
b.Install valve A, valve B, valve C and valve D in inlet pipeline, outlet
pipeline, the middle of the inlet and outlet pipeline. valve D is sampling
valve.
c. Install a check valve in water outlet
d. Inlet pipeline should be in parallel with outlet pipeline. Support inlet and
outlet pipeline with fixed holder.
Note:
If making a soldered copper installation, do all sweat soldering before
connecting pipes to the valve. Torch heat will damage plastic parts.
When turning threaded pipe fittings onto plastic fitting, use care not to
cross thread or broken valve.
To Next Page
Loading...
