Need help?Do you have a question about the Rupes BR133AE and is the answer not in the manual?
Before starting, check packaging, completeness, energy source, and plug-in sockets for rated power.
Safety and accident prevention instructions are detailed in the separate "Safety Rules" leaflet.
Procedure to fit the working disk by pressing the blocking button and manually screwing it.
How to fix abrasive paper disks, ensuring dust extraction holes align with the working disk.
Verify power source, cable condition, switch function, part installation, ventilation, and dust extraction.
Instructions on how to switch the machine on and off using the power switch.
Test the machine after switching on to check for excessive vibrations or disk damage.
Adjust motor speed using the control knob based on material characteristics.
Adjust the dust extraction rate by rotating the adjustment ring.
Perform abrasive material replacement following specific fastening procedures.
Perform maintenance after disconnecting power. Clean dust using compressed air; internal cleaning by authorized centers.
Tests performed according to EN 50144-1 and EN 50144-2-4 standards for power tool safety.
Machine compliance with EN 55014-1, EN 55014-2, EN 61000-3-2, and EN 61000-3-3 standards.
The noise level is 77 dB, measured according to EN 23744 standard. Use hearing protection.
Average acceleration is below 2.5 m/sec², measured according to EN 28662 standard.
Details the 12-month warranty, coverage limitations, and repair service procedures.
Explanation of the symbols and data found on the machine's rating plate.
General| Orbit Diameter | 3 mm |
|---|---|
| Weight | 1.3 kg |
| Pad Size | 125 mm |
| Cable length | 4 m |
| Dust extraction | Yes |
To Next Page
