4
13 The bottom of the funnel feeds directly into the reservoir.
14 Prime the iron before use – see below.
the other way
15 Reach under the end of the reservoir, raise the reservoir release, and slide the
reservoir out of the base unit.
16 Pour water into the hole in the top of the reservoir, up to, but not over x.
17 Slide the reservoir into the base unit.
18 Check that the catch on the reservoir clicks into place in the base unit.
19 Prime the iron before use – see below.
C SWITCH ON
20 Set the iron on top of the base unit.
21 Check that the clamps are in the release position (press U).
22 Lift the iron off the base unit, unwind the steam pipe from its niche above the
reservoir and cable storage, then set the iron back on the base unit.
23 Open the cable storage ((), pull out the plug and all the cable, thread the cable
through the adjacent gap, and close the cable storage.
24 Put the plug into the power socket (switch the socket on, if it’s switchable).
• The 2 button will blink red.
25 Press the 2 button to switch the appliance on.
• The 2 button will stop blinking and glow green.
• The r button will glow, to show that the boiler is operating.
• The S button will blink, to show that steam is being generated.
• The # light will glow
26 Press the S button to choose the steam level you want.
• The steam level lights are: S = low, ~ = medium, # = high.
27 When the S button glows steadily, the boiler is ready to make steam.
28 It’ll then cycle on and off as the boiler works to maintain the temperature.
29 If the temperature control on the iron is set above room temperature, the
thermostat light on the iron will glow, to show that the soleplate is heating up.
30 It’ll go out when the soleplate reaches the temperature set by the temperature
control, then cycle on and off, as the thermostat works to maintain the temperature.
C PRIMING
31 Prime the iron after filling the reservoir, to get water and steam through the system.
32 Hold the iron below the level of the base unit, and squeeze the steam trigger.
33 You’ll hear the pump as it pushes water through the system, then, after 30 seconds
or so, it’ll start to quieten, and steam will come out of the soleplate.
34 The iron is now primed and ready for use.