Russell Hobbs RHCM47 - Intensive Clean of the Portafilter and Milk Tank System

15
 Fill the milk tank with water
 Push out the milk nozzle (8) using the lever (7)
 Press the power button (16) to switch on the machine and preheat the water. The
control panel flashes during the heating process.
 Place a suitable cup below the milk nozzle.
 As soon as the machine has heated up, the control panel stops flashing. Press the self-
cleaning button (20). A beep sounds, the self-cleaning starts and the self-cleaning
button flashes.
 Run the program and pour away the contents of the cup after the self-cleaning finishes.
 Repeat this process if necessary.
Intensive Clean of the Portafilter and Milk Tank System
During the intensive clean, the portafilter is also thoroughly rinsed through in addition to the milk
tank system. This allows coffee residues which are stuck on to be rinsed out of the portafilter and
the filters if applicable.
 Fill the water tank (2) with water
 Also fill the milk tank with water
 Push out the milk nozzle (8) using the lever (7)
 Press the power button (16) to switch on the machine and preheat the water. The
control panel flashes during the heating process.
 Place a suitable cup below the coffee outlet (14) and the milk nozzle.
 As soon as the machine has heated up, the control panel stops flashing. Press the self-
cleaning button (20) for approx. 5 seconds. A beep sounds, the self-cleaning starts and
the button flashes.
 If you want to stop the cleaning, press the button (20) again. The machine switches to
stand-by mode.
 Dispose of the water in the cup.
 Repeat this process if necessary.