17
The mains plug is not
inserted correctly in the
plug socket.
The plug socket is defective. Try another plug socket.
No mains voltage is present.
Check the fuse of the mains
connection.
The control panel lighting is
defective.
Contact our customer
service department.
Too many devices
connected to the same
circuit.
Reduce the number of
devices in the circuit.
No error can be identified.
Contact our customer
service department.
There is too much water in
the water tank (2).
Do not overfill the water
tank!
The water tank is not placed
in its mount correctly.
Correctly fit the water tank.
1. Detach the water tank
from the device and fill it
with water (see the
“Handling and Operation”
chapter | “Filling the Water
Tank”).
2. Place a cup underneath.
3.Then press any button.
Some water will run through
the water system into the
cup. The device will stop
beeping, the red indicator
light goes out and the
device can be restarted.
4. Select the function you
want again.
The control panel (3) does
not light up / the device
cannot be switched on.
The fuse in the fuse box is
triggered.
Water runs out of the
device.
A function has been
selected, but the device
beeps constantly and the
red indicator light (18)
flashes. The control panel
does not light up.
There is no water in the
water tank.
TROUBLE SHOOTING
To Next Page
Loading...
