The following things should be checked before starting the dishwasher.
The content of this manual is very helpful t o the u sers.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
T he inl et va lve i s o pen
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he i nlet and drai n hos es a re kno tted
7
All packing materials and printings should be taken out from the dishwasher
Extension Hose
If you need a drain hose extension,make sure to usea similar drain hose.
It must be no lon ger th an 4 m etres; otherw ise the cleani ng effect of the di sh washer coul d be reduced .
Wa t e r O u t l et
Connect the wa ter d rain h os e. The dr ain h ose mu st be cor rectly fit te d t o av oid w at er lea ks.
Ensur e that the w ate r dra in h ose is no t kin ked or s quashed .
I f the s ink is 1 000 h igher f r om the f l oor, t he ex cess w a te r i n h o se s ca nno t b e dr ai ne d di rec tl y
into the sink. Itwill be necessary todrain excesswater from hoses into a bowl or suitable
containe r tha t is held outside and lower th an t he si nk.
How to Drain Excess Water From Hoses
Syphon Conn ection
Th e waste conn ec tion mus t be at a height l e s s t han 100 0 m m (m axi m u m) f rom t he bo t tom o f t he di s h.
The wat er dr ain h ose sho uld be f ixed .
To Next Page
Loading...
