Overflow .
Whe n some m alfu nctions come on, the appli ance will display error codes to warn you:
Longer inl et time.
Faucets is not op ened, or wa ter intake is
restricted,or water pressure is too low.
Some element of dishwasher leaks .lem
T he R a pid lig ht fl icke r fle et ly
The E CO l igh t f lic ker fle etly
The dishes were not
loaded correctly .
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Tab le ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unl oading the dishwasher only once t
he dishes are barel y warm to the touch. Empty the low
bas ket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleani ng performance. Choose
a program with a long wa shing time.
Water drainage is more d ifficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerf ul enough.
Not enough detergent
was dispen sed.
Items are blocking
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is n ot correctly fit t ed.
This may cause
the sp ay arm jets
to g et blocked.
r
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dis hes.
Dishes block
detergent cups.
Improper loading
Too little rinse -aid
Dishes are removed
too soon
Wr ong program
has been selected
Use of cutlery with
a low-quality coating
Open circuit or break of distributary valve.
Failure of orientation of distributary valve.
The G la ss li ght flicker fleetl y
To Next Page
Loading...
