The Russell Hobbs Glass Table Top Wine Cooler, model number RHGWC4B (SS) (-LCK), is a compact refrigerating appliance designed exclusively for the storage of wine. It is intended for adult use and should not be used for freezing foodstuffs.
Function Description:
This appliance functions as a wine cooler, maintaining a controlled temperature environment for wine bottles. It features an interior light that can be switched on and off, and a thermostat dial for temperature regulation. The cooling system utilizes natural refrigerant gas, R600a (Isobutene), which is environmentally friendly. Some models are equipped with a lock and keys for secure storage.
Important Technical Specifications:
- Model Number: RHGWC4B (SS) (-LCK)
- Rated Voltage: 220V – 240V ~ 50Hz
- Capacity: 20 bottles (75cl) / 62L total storage volume
- External Dimensions (HxWxD): 630mm x 430mm x 480mm
- Storage Temperature Range: 5°C - 18°C
- Energy Consumption: 135 kWh/year
- Energy Rating: G
- Light Energy Efficiency Class: Exempt (uses energy-efficient, long-life LED)
- Defrosting Type: Static
- Climate Class: SN/N (intended for ambient temperatures between 10°C and 32°C)
- Extended temperate: 10°C to 32°C
- Temperate: 16°C to 32°C
- Subtropical: 16°C to 38°C
- Tropical: 16°C to 43°C
- Airborne Acoustical Noise: 40 dB
- Compartment Humidity Range: 50%-80%
- Rated Current: 0.55A
- Net Weight: 21.3/22.3 KG
- Refrigerant: R600a (Isobutene)
Usage Features:
- Installation: The appliance should be placed on a flat, firm, and well-ventilated surface, away from direct sunlight and heat sources like stoves or ovens. A minimum clearance of 10cm from heating cores, 10cm from chest freezers/freezers, 5cm from kitchen cabinets, and 6cm from the back wall is recommended. At least 30cm clearance above the appliance is needed. It must be plugged into an earthed socket and should not be used outdoors or on carpeted surfaces. After transport, allow the appliance to stand upright for a minimum of 3 hours before plugging it in to allow the coolant to settle.
- Temperature Control: The temperature is regulated by a dial located inside the appliance, next to the light. Settings range from 1 (warmest) to 7 (coldest), with 0 being off. For normal conditions, the temperature control should be set between 6 and 7, aiming for an internal temperature between 5°C and 18°C. The temperature of stored items and door opening frequency affect internal temperature.
- Interior Light: An LED light is located at the top inside the appliance and can be turned on or off via a switch.
- Door Reversal: The door can be reversed to open from the opposite side. This process involves tilting the cooler backward (no more than 45 degrees), unscrewing hinges and brackets, moving the hinge stopper (for RHGWC4SS & RHGWC4SS-LCK models), and reattaching components. Tools required include a Philip head screwdriver, flat-headed screwdriver, and hexagonal spanner. After reversal, the appliance must remain upright for at least 3 hours before use.
- Lock & Keys (selected models): Some models include a lock at the bottom of the door and two keys. To lock, insert a key and turn clockwise until the metal pin engages. To unlock, turn counter-clockwise. The locking plate can be adjusted if needed.
Maintenance Features:
- Internal Cleaning: Disconnect the appliance from the power supply before cleaning. The interior cavity should be cleaned periodically with a solution of bicarbonate of soda (5ml to 0.5 litre of water) and lukewarm water. Accessories should be cleaned separately with soap and water; do not use a dishwasher. Avoid abrasive products, detergents, or soaps. Rinse with clean water and dry carefully. Reconnect the plug with dry hands.
- External Cleaning: Wash the outer cabinet with warm soapy water; do not use abrasive products. Exercise caution due to sharp edges on the underside. Once or twice a year, dust the rear of the appliance and the compressor with a brush or vacuum cleaner to prevent dust accumulation, which can affect performance and energy consumption.
- When Not in Use: For long periods of disuse, disconnect from the electricity supply, empty all contents, clean the interior, and leave the door open to prevent odor buildup.
- Energy Saving Advice:
- Avoid installing near heat sources.
- Ensure good ventilation and clear air vents.
- Minimize door opening frequency and duration.
- Keep door seals clean and intact.
- Do not overload the appliance.
- Allow hot items to cool before placing them inside.
- The factory-set shelf placement provides the most energy-efficient usage.
Troubleshooting:
The manual provides a troubleshooting guide for common issues such as the cooler not working (check power, fuse, voltage, socket), insufficient cooling (check overload, thermostat setting, direct sunlight, ambient temperature, door opening frequency), excessive cooling (adjust thermostat to a lower setting), and wet internal/external surfaces (caused by condensation, dry carefully). It also addresses unusual noises like bubbling, gurgling, water flowing, and compressor noise, explaining them as normal operational sounds.
Safety Instructions:
- Ensure the supply cord is not trapped or damaged during positioning.
- Do not locate multiple portable socket-outlets or power suppliers at the rear.
- The appliance uses R600a refrigerant, which is combustible; handle with care to avoid damaging refrigeration circuit components.
- Do not obstruct ventilation openings.
- Do not place or rest the appliance on its power cord.
- Do not use mechanical devices or artificial means (e.g., heaters, hair dryers) to accelerate defrosting.
- Do not use electrical appliances inside the cooler compartment.
- If replacing an old cooler with a lock, remove the lock as a safety measure.
- Dispose of old refrigerators, coolers, and freezers properly, contacting local authorities or dealers. Do not damage the scrap unit.
- Do not use adaptors or extension leads.
- Do not plug in damaged plugs.
- Do not pull, twist, or damage the power cable.
- Do not plug in or unplug with wet hands.
- Children aged 8 and above, and persons with reduced capabilities, can use the appliance with supervision and understanding of hazards. Children aged 3 to 8 are allowed to load and unload.
- Do not allow children to play with the appliance or hang on the door.
- Do not place explosive or flammable material inside.
- Do not cover the body or top of the appliance.
- Fix accessories during transportation.
- If left empty for long periods, switch off, defrost, clean, dry, and leave the door open.
- This appliance is not intended as a built-in appliance.
Need help?
General
To Next Page