8
IMPORTANT INFORMATION FOR RELIABLE AND SAFE OPERATION
REMOVAL AND INSTALLATION OF THE ANTI-BLOCK SHIELD AND THE GASKET
1. Prior to each use, inspect and ensure the gasket, anti-block shield, red oat valve and red
oat valve seal are clean, correctly tted to the lid.
2. Thoroughly clean after each use to ensure all food residues are removed.
3. Never stretch the gasket as this may affect sealing and pressure effectiveness of the
appliance.
4. If the gasket becomes damaged it should not be used. Contact customer service for a
replacement.
Note: Always ensure the anti-block shield and gasket are clean and in place before cooking.
REMOVAL AND INSTALLATION OF THE ANTI-BLOCK SHIELD:
To remove: Twist and lift upwards
To install: Push down into position
IMPORTANT: Also check the red float valve and seal are clean and in place before cooking.
REMOVAL AND INSTALLATION OF THE GASKET:
To remove: starting at one point, slowly pull the gasket up, continue to
gently pull upwards until the whole gasket is removed from the metal ring
inside the lid.
To install: Place the gasket on top of metal ring inside the lid. Press
down gently all the way around until the gasket sits in place securely
around the metal ring.
Anti block shield
To Next Page
Loading...
Need help?
General
