Russell Hobbs RHWU88 - Boil-Dry Protection and Maintenance; Boil-Dry Protection Reset; Care and Maintenance Guide; Regular Descaling Procedure

BoiL-Dry proteCtion
Note: To prevent the boil-dry feature activating, always make sure water is visible in the water
gauge.
• Theurnisprotectedbyathermallimiterwhichcanbemanuallyreset.Themanualreset
button is located under the base of the urn.
• Iftheurnhasboileddry,thethermallimiterwillautomaticallyswitchofftheelement.The
lights will also remain off until manually reset.
Note: The urn must be unplugged before it can be reset.
• Toresettheurn,waituntiltheappliancehascooleddown.
• Presstheresetbutton.
• Addwateruntilvisibleinthewatergauge.
• Plugthepowercordintothewallpoweroutletandswitchiton.
• SettheOn/OffswitchtotheOnposition,checkifthe"Heating"lightison.Ifthelightison,it
indicatestheurnhasrecoveredtonormalworkingcondition.
• Ifthe“Heating”lightisstilloff,switchoffthepowerandremovetheplugfromthewallpower
outletandrepeattheaboveprocessagain.Thismayneedtobedoneseveraltimesuntilthe
urn returns to normal working condition.
• Iftheresettingprocessdoesnotswitchtheurnbackon,pleasecallcustomerservice.
Note: This facility is for the protection of the user as well as the components. Do not attempt to
bypass the boil dry protection.
Care anD MaintenanCe
• Switchthepoweroffandremovetheplugfromthewallpoweroutlet.
• Allowtheurntocooldownfully.
• Wipeovertheoutsideoftheurnwithadampcloth.Amilddishwashingdetergentmaybe
usedifrequired.
• Ensurethepowercordandswitchesremaindry.
• Donotimmersetheurninliquid.
• Donotuseharshorabrasivecleaningagentsorsolvents.
De-sCaLe reguLarLy
To maintain the performance of your urn, it should be descaled every three months or so. Descale
more frequently if you live in a hard water area.
• Fillyoururnwithfreshwatertothe10cupmarkonthewatergauge.
• Add4to5teaspoonsofcitricacidoraproprietarydescalingproducttothewaterintheurn.
• SwitchtheOn/OffswitchtotheOnposition.
• Allowthewatertoheatuntilthe‘Hot’lightilluminates.LeavetheurnOnforanadditional
15minutes.
• SwitchtheOn/OfftotheOffpositionandallowtheurntocool.
• Draintheurnthroughthewatertap.Therewillbesomewaterremainingintheurn
– carefully lift the urn and pour out the remaining water.
• Rinseouttheurnwithfreshwatertoremoveanydescalingsolutionresidue.