5
25. For added safety, electrical appliances should be connected to a power outlet that is protected by a
residual current device (RCD), also often referred to as a ‘Safety Switch’. Your switchboard may already
incorporate an RCD. If unsure, call an electrician for verification and fitting if necessary.
This appliance is intended to be used in household and similar applications such as:
• staff kitchen areas in shops, offices and other working environments;
• by clients in hotels, motels and other residential type environments;
• bed and breakfast type environments;
• farm houses.
CAUTION: Benchtops, such as, but not limited to, engineered stone, marble, granite and acrylic
may not be tolerant of localised temperature rises. Therefore, any appliance that radiates heat
should be placed on a heat resistant pad or chopping board to prevent the heat from affecting
the benchtop.
SAVE THESE INSTRUCTIONS
PARTS
26. Touch controls and display
27. Body
28. Crisping plates
29. Baskets
30. Basket dividers
31. Basket connector
BEFORE USING FOR THE FIRST TIME
• Handwash the removable parts, rinse, and dry.
• When using your air fryer for the first time, you may notice smoke or a slight odour for the first few
minutes of cooking. This is normal. Ensure the room is well ventilated.
• Place the crisping plates into the baskets. Slide the baskets into the body.
PREPARATION
• Sit the appliance on a stable, level, heat-resistant surface.
• Leave a space of at least 50mm all-round the appliance.
• Have oven gloves (or a tea towel) on hand, use heat resistant plastic tongs and a heat-resistant mat or
dinner plate to rest the basket on.
• Note: Do not use metal tongs as it may scratch the coating. We recommend using only heat resistant
plastic or silicon coated tongs.
ASSEMBLING THE BASKETS
To use one large basket
1. Remove the baskets from the body.
2. If present, slide the basket dividers out of each basket (A).
3. If they are not already fitted, place a crisping plate into each basket (B).
4. Place the basket side by side so that they are touching (C).
5. Align the basket connector with the grooves on both sides of the baskets simultaneously. Slide both
sides of the basket connector downward at the same time while applying outward pressure to both
sides of the basket connector so that it attaches to both grooves at the same time (D).
To Next Page
Loading...
