WIRING INSTRUCTIONS
1. Connect the leads from the amplifier’s outputs to
the connector labeled input. The wires should stay
consistent, left + of the amplifier to left + input of
the volume control, observing polarity and
identification.
CAUTION: Do not reverse the input and output
connections!!
CAUTION: A majority of receivers are designed to
operate at a rating of 8Ω. On receivers that offer A
and B speaker outputs, both A and B connections
share the same amplifier. It is important to note, due
to the way many receivers are wired, that when
using impedance matching devices, such as
UltraMatch™ volume controls, it is recommended
to wire all speakers to the A output. If you have any
questions contact Russound directly.
2. As outlined in step #1, connect the speaker wires to
the connector labeled output.
3. Install the completed assembly in the junction box.
Insert carefully to avoid excessive strain on the
connector. Taking the time to feed the excess
wire out the back of the junction box will help
you with the final assembly.
To Next Page
