4
ENG
GAS CYLINDER
• The gas cylinder must not be dropped or handled carelessly.
• If the barbecue is not used, the gas cylinder must be disconnected and the safety cap
mounted.
• The gas cylinder must never be placed so that it is exposed to temperatures over
50° C. Therefore, do not place the gas cylinder directly under the barbecue. The gas
cylinder must also never be placed or stored in places where there is a risk of fire or
sparks, for example.
• Do not smoke in the immediate vicinity of the gas cylinder.
•
•
It is prohibited to make any modifications to the gas cylinder. This can be fatal.
Maximum gas cylinder size is H:800 x W:350 mm.
CONNECTING THE GAS CYLINDER TO THE BARBECUE
• Make sure the gas cylinder’s valve is closed.
• Connect the regulator to the gas cylinder.
• Connect the hose to the barbecue’s connector.
• Make sure that the hose is not clogged, knotted or lying against any part of the
barbecue other than the connector.
• Check for leaks in the gas cylinder, regulator, hose and barbecue before starting to
barbecue. See the section "Checking for leaks".
CHECKING FOR LEAKS
• Mix 50% soap with 50% water. Make sure that the gas valve on the gas cylinder is
closed and that the pinion on the barbecue is closed.
• Put a soap solution on the gas cylinder’s valve, the regulator, the hose and the connector
to the barbecue.
• Open the gas valve on the gas cylinder. If there are small bubbles in any of the
previously mentioned parts, this means that there is a leak.
• Close the gas valve and tighten the hose connectors. Perform the test again.
If there is still a leak, contact your Rusta warehouse
.
To Next Page
Loading...
Need help?
General
