800.851.7347 www.rycominstruments.com
note: thIs setup procedure Is not requIred unless the user desIres to chanGe factory settInGs.
The STICK operating programs and frequency sets are user programmable
and can be changed at anytime through a quick selection process.
To select the desired frequency set on the RECEIVER:
• Press, and hold depressed, the Power on BuTTon.
• Pressing the FreQuencY BuTTon will toggle through available frequencies.
Passive 50Hz, 60Hz, cP50Hz, cP60Hz, 512Hz, 815 8kHz, 9kHz, 33kHz, 65kHz, 82kHz,
200kHz, 478kHz
• To select a frequency, press the MODE BuTTon toggle. At the top of the LCD
the count of frequencies selected will tally up one each time a frequency is
selected.
• Pressing the GAIN UP BuTTon will change the depth reading from inches/feet to
centimeter.
• A long press of the mode BuTTon will toggle on and off the optional ferrous locating
feature (Fe).
• Releasing the Power on BuTTon will exit the setup menu and save
the selected frequencies for availability during normal operation.
To select the desired frequency set: on the TRANSMITTER
• Press and hold depressed the Power on BuTTon.
• Pressing the inFormaTion BuTTon will toggle through available configurations. Repeat
pressing until U3 is displayed in the FreQuencY indicaTor section of the LCD.
• Press and hold depressed the Power on BuTTon.
• Without releasing the Power on BuTTon, press the FreQuencY BuTTon to toggle through
the available frequencies.
• To select and store the desired frequency press the inFormaTion BuTTon. The count
of the selected frequency will be displayed on the LCD.
• Continue to toggle through and select the desired frequencies,
• Releasing the Power on BuTTon will save the selected frequencies for availability
during normal operation.
Changing Operating Modes & Frequency Sets
To Next Page