Need help?Do you have a question about the Rycom STICK Locating Series and is the answer not in the manual?
Instructions for unpacking and initial setup of the Stick Locator, including battery installation.
Method to find the peak signal over a buried utility by moving the receiver left to right.
Instructions on how to attach a sonde to a push rod or sewer auger using couplings or tape.
Instructions for unpacking and initial setup of the Stick Locator, including battery installation.
Method to find the peak signal over a buried utility by moving the receiver left to right.
Instructions on how to attach a sonde to a push rod or sewer auger using couplings or tape.
General| Protection Rating | IP54 |
|---|---|
| Frequencies | 512Hz, 640Hz, 8kHz, 33kHz |
| Depth Accuracy | ±5% (Typical) |
| Operating Temperature | -10°C to +50°C |
| Output Power | 1W |
To Next Page