Need help?Do you have a question about the Ryobi BIW180 and is the answer not in the manual?
General| Brand | Ryobi |
|---|---|
| Model | BIW180 |
| Category | Impact Driver |
| Language | English |
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Avoid body contact with earthed surfaces. Do not expose power tools to rain or wet conditions.
Stay alert, use protective equipment, prevent unintentional starting.
Do not force tool, use correct tool, maintain tool, disconnect before adjustments.
Wear ear protectors with impact wrench. Exposure to noise can cause hearing loss.
This product is suitable for fastening and removing screws and bolts.
Battery electronics may signal shutdown; release trigger to reset. Avoid forcing tool.
Place rotation selector in center, then insert battery pack until latches snap.
Depress latches on both sides of the battery pack to remove it from the impact wrench.
Depress trigger to turn ON, release to turn OFF. Can be locked in OFF position.
Trigger pressure controls speed. Higher pressure means higher speed.
Controls forward/reverse rotation. Center position locks the switch trigger.
Use correct size impact sockets. Push socket onto drive shank until it locks. Pull to remove.
Hold tool straight, fasten for appropriate time. Determine torque via test operation, check with torque wrench.
Set rotation selector, hold tool, place bit on screw, depress trigger slowly. Impacting begins as screw is driven.
Use identical replacement parts. Wear safety goggles. Remove battery pack before cleaning.
Avoid solvents on plastic. Use clean cloths for dirt, dust, oil, grease.
To Next Page
