10
OPERATION
2. Pull the choke lever fully out. (Fig.10-A)
3
. Press the primer bulb 3 to 5 times. (Fig.10-B)
4. Set the ignition swith to the “I” ON position.
(
Fig.11)
5
. Place the saw on a firm and level surface. Hold
the saw securely with your foot as illustrated in
Fig.12. Pull the starter 3 to 5 times. Stop when
the engine tries to fire. Push the choke knob
back in (Fig.10-A) and then pull the starter
again several times until the motor starts.
6. When the motor starts let it idle of a couple of
seconds to warm up. Apply part throttle (Fig.13)
and maintain the unit at a low to Medium speed
for a further 10 seconds.
7. Disengage the chain brake by pulling back the
chain bake lever and bringing the motor to
cutting speed. (Fig.14)
STOPPING
1. To STOP the motor set the ignition switch
(Fig 15-A) to the “0” OFF position.
NOTE. To stop the engine in an
emergency, activate the chain brake and
switch the ignition switch the “0” OFF
position.
Fig. 10
Fig. 11
Fig. 12
Fig. 15
Fig. 13
Fig. 14
A
B
A
A
A
To Next Page
Loading...
Need help?
General
