Page 6
ADJUSTMENTS
WARNING: To prevent accidental
starting that could cause possible
serious personal injury, assemble all
parts to your saw before connecting it
to the power supply. The saw should
never be connected to power supply
when you are assembling parts, making
adjustments, installing or removing
blades, or when not in use.
As mentioned previously your saw has been factory
assembled and adjusted. The dust bag, vice,
material supports and the mitre table lock handle are
the only parts that have to be installed.
■ REPLACING BLADE (Fig 10)
DANGER: A 254mm x 1.8mm diameter
blade is the maximum blade capacity of
your saw. Never use a blade that is too
thick to allow outer blade washer to
engage with the flats on the spindle.
Larger blades will come in contact with
the blade guards, while thicker blades will
prevent the blade screw from securing the
blade on the spindle. Either of these
situations will result in a serious accident
and can cause serious personal injury.
Remove the two lower guard arm screws and raise
the lower guard. (Fig 9)
Depress the blade lock button while rotating the
blade. The blade lock button will move into the blade
lock position. (Fig 10)
Remove the blade bolt and outer blade flange and
replace the blade. Reattach the outer blade flange
and secure the blade bolt tightly and reattach the
lower blade guard. (Fig 11)
WARNING: If the inner blade washer has
been removed, replace it before placing
blade on spindle. Failure to do so could
cause and accident since blade will not
tighten properly.
CAUTION: Always install the blade with
the blade teeth pointing in a downward
direction.
Fig 9
Lower
Blade
Guard
Lower Blade Guard
Arm Screws
Fig 10
Fig 11
To Next Page
Loading...
