Ryobi ERT-1150VN User Manual

Keep work area clean, avoid explosive atmospheres, and keep bystanders away.

Avoid grounded surfaces, protect cord, use outdoor extension leads.

Stay alert, dress properly, avoid accidental start, proper footing, use safety equipment.

Hold tool by insulated surfaces when cutting tool may contact wiring.

Know tool, wear safety glasses, protect lungs and hearing.

Powerful 1.5 HP motor for tough routing jobs.

Plastic shield on base for protection against flying dust and chips.

Secures spindle for easy cutter changes; do not run with lock engaged.

Electronic control for adjustable speed from 14,000-31,500 RPM.

Allows free plunging and depth setting; adjustable for wear.

Instructions for installing cutters, including adaptor use and tightening.

Guidance on making cuts in multiple passes for safety and quality.

How to turn the router ON and OFF using the lock-off button and switch.

Illuminates when the tool is connected to supply, indicating it is live.

General steps for routing, including holding the router and starting the cut.

Basic techniques for signs, relief sculptures, and patterns into wood.

Disengages adjuster for large plunge depth adjustments.

Avoid solvents on plastics, use clean cloths, keep tool clean from dust.

Bearings are lubricated for life; no further lubrication is required.

Keep cutters clean and sharp for best results.

Clean collet and shaft taper; proper installation and care of collet.