Ryobi P530 - Using the Circle Cutter; Circle Cutting Procedure; Cutting Caution

13
USING CIRCLE CUTTER
See Figure 9.
n Assemble circle cutter if necessary. Refer to “Assembling
Circle Cutter” in this manual.
n Attach circle cutter to speed saw if necessary. Refer to
“Attaching Circle Cutter” in this manual.
n Adjust depth of cut if necessary. Refer to “Adjusting
Depth Of Cut” in this manual.
n Loosen pivot point knob.
n Move pivot point knob to desired diameter dimension.
n Tighten pivot point knob.
n Start speed saw.
n Cut a pilot hole in the center of the intended circle.
n Line up pivot point knob with the lead hole.
n Begin cut, applying moderate, steady pressure.
n Hold the speed saw firmly with one hand and the handle
with the other.
CAUTION:
Too much force causes heat build up, which can shorten
the life of the bit.
n Work in a clockwise direction, continuing back to the
starting position.
n Stop speed saw.
Fig. 9
OPERATION