To Next PageTo Next Page
Need help?Do you have a question about the Ryobi r163 and is the answer not in the manual?
General| Voltage | 120V |
|---|---|
| Cord Length | 6 ft |
| No Load Speed | 25, 000 RPM |
| Type | Router |
| Collet Size | 1/4 in |
Keep work area clean and well-lit; avoid explosive atmospheres; keep children away.
Use proper plugs, avoid earthed surfaces, protect from wet conditions, handle cords carefully.
Stay alert, use PPE, prevent unintentional starting, remove tools before operation.
Use correct tool, ensure switch works, disconnect power before adjustments, maintain tool.
Have tool serviced by qualified personnel using identical replacement parts.
Hold by insulated surfaces, use clamps to secure workpiece for stability and control.
Wear eye protection, dust mask, and hearing protection as needed for safety.
Inspect cords for damage, use outdoor-rated extension cords of appropriate gauge.
Know the tool, remove nails from lumber, save instructions for future reference.
Explains DANGER, WARNING, CAUTION, NOTICE signal words used in the manual.
Details symbols like Safety Alert, Read Operator's Manual, Eye Protection, and electrical units.
Explains the safety concept eliminating the need for grounding and isolating metal parts.
Specifies voltage, frequency, and current type (120V AC, 60Hz) for connection.
Guides on selecting proper gauge and type of extension cords for safe use.
Lists technical details like depth of cut, collet size, horsepower, and no load speed.
Combines general assembly warnings and California Proposition 65 warning.
Reminds users to stay alert, wear eye protection, and lists tool applications.
Steps for removing/installing the base and managing router bits.
How to select, set, and adjust the router's depth of cut.
Covers internal, edge, freehand routing, pilot bits, and feed direction.
Discusses selecting feed rate and consequences of feeding too fast or too slow.
Importance of depth of cut, recommendations for single pass depth, and multi-pass technique.
How to tighten the lock lever tension for secure motor housing clamping.
Advice on cleaning parts, warnings about solvents and materials.
States no lubrication is needed and recommends authorized service for cord replacement.
Instructions for cleaning and sharpening bits, and cleaning the collet.
Lists available accessories such as edge guides and carbide router bit kits.
Labels and identifies the main parts of the Ryobi R163/R163G router.
Illustrates base assembly, bit mounting, and associated controls.
Depicts various routing methods like internal, edge, and freehand cuts.
Shows how depth of cut is measured and how to adjust the lock lever tension.
