7
or into a container approved for liquid waste.
To clean the cable:
Remove the battery pack from the tool.
2. Using a clean cloth and warm soapy water, pull the
cable out from the tool, cleaning it as it advances.
Continue until the cable has been fully advanced and
completely cleaned.
Using a clean, dry cloth, push the cable back into the
tool, drying it as it retracts. Continue until the cable has
been fully retracted.
4. To ensure that no water entered the tool, drain the drum
as described earlier.
5. Place the cap on the end of the cable.
NOTICE: Do not advance or retract the cable using the
switch trigger unless the cable is in a drain pipe.
MAINTENANCE
WARNING
Always remove the battery pack from the product
and disconnect from the power supply when you
are assembling parts, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
Ŷ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and can be damaged by their
use. Use dry cloths to remove dirt, dust, oil, grease, etc.
WARNING
'RQRWDWDQ\WLPHOHWEUDNHÀXLGVJDVROLQHSHWUROHXP
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
Ŷ When servicing, use only original manufacturer’s
replacement parts. Use of any other part could create a
hazard or cause product damage.
Ŷ Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
Ŷ For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
VXI¿FLHQWDPRXQWRIKLJKJUDGHOXEULFDQWIRUWKHOLIHVSDQRI
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Please read the instructions carefully
before starting the machine.
V Volts
Direct current
Do not expose to rain or use in damp
locations.
Wear protective gloves
Wear eye protection
Risk of long hair being drawn into
rotating drum.
Risk of loose clothing being drawn into
rotating drum.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
The following signal words and meanings are intended to
explain the levels of risk associated with this product:
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that
may result in property damage.
To Next Page
Loading...
