depressing the trigger. The drill will begin small rotations at
a manageable speed. Release the trigger once the desired
depth is achieved.
When using e-Torque control it is important to ensure the
screw bit is correctly seated and does not slip from the
screw head. If the screw bit is incorrectly tted the drill may
stop early to prevent damage to the screw head or bit. If
this occurs, realign the bit with the screw head and depress
the trigger again.
NOTE: e-Torque control works with most materials and
applications but may not operate with certain materials or
screws, e.g., machine screws into metal or plastic threads.
SYMBOLS
Safety alert
CE conformity
V Volts
Direct current
min
-1
Revolutions or reciprocations per minute
Chuck capacity
No-load speed
EurAsian Conformity Mark
Please read the instructions carefully
before operating the product.
Ukrainian mark of conformity
Drilling without impact
Auto screw driving mode
Percussion Drill
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.
SYMBOLS IN THIS MANUAL
Note
Parts or accessories sold separately
Speed, minimum
Speed, maximum
The following signal words and meanings are intended to
explain the levels of risk associated with this product:
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
(Without Safety Alert Symbol) Indicates a situation that
may result in property damage.
4
To Next Page
Loading...
