EasyManuals Logo

Ryobi R4SDP-L13C User Manual

Ryobi R4SDP-L13C
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
2 | English
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
Unplug charger from outlet before
attempting any maintenance or
cleaning to reduce the risk of electric
shock.
Disconnect charger from the power
supply when not in use. This will
reduce the risk of electric shock or
damage to the charger if metal items
should fall into the opening. It also will
help prevent damage to the charger
during a power surge.
Risk of electric shock. Do not
touch uninsulated portion of output
connector or uninsulated battery
terminal.
BATTERY SAFETY WARNINGS
Li-ion
Do not dispose of used battery packs
in the household refuse or by burning
them. To ensure proper disposal of
waste battery packs and protect the
environment, hand over old battery
packs to your Ryobi distributor.
Segregate electronic waste properly
by removing integrated battery packs
from the main unit before disposal.
Hand them over to applicable
collection points.
To remove the integrated battery
pack: Separate the housing shells
from one another by removing the
screws. Disconnect the battery pack
from the circuit and remove.
NOTE: When opened, the product is
no longer reusable or serviceable and
should be disposed of properly.
Before removing the battery pack
from the power tool, switch on the
product until the battery pack is fully
discharged.
Ensure that the battery pack to be
disposed of cannot come in contact
with batteries, other battery packs,
or conductive materials by protecting
exposed connectors with insulating,
non-conductive caps or tape.
Never charge a damaged battery
pack.
RESIDUAL RISKS
Even when the product is used as
prescribed, it is still impossible to
completely eliminate certain residual risk
factors. The following hazards may arise
and the operator should pay special
attention to avoid the following:
Damage to hearing caused by noise
Wear suitable hearing protection and
limit exposure.
Injury to the eyes
Wear protective eye shields or goggles
when using the product.
Injury caused by vibration
Limit exposure. Follow the instructions
in Risk Reduction.
Electric shock caused by contact with
hidden wires
Hold the product only by insulated
services.
Injury caused by dust
Dust created by operating the product
can cause respiratory injury. Wear
appropriate dust control mask with
filters suitable for protecting against
particles from the material being
worked on.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ryobi R4SDP-L13C and is the answer not in the manual?

Ryobi R4SDP-L13C Specifications

General IconGeneral
BrandRyobi
ModelR4SDP-L13C
CategoryPower Screwdriver
LanguageEnglish

Related product manuals