Deutsch (Übersetzung der originalen Anleitungen)
24
English (Original instructions)
■ Always stop the engine and make sure all moving
parts have come to stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
● removing blade
● installing blade
WARNING
Never use cutting means or attachments which are not
specified by Ryobi in this manual. This includes the use of
metal multi-piece pivoting chains and flail-blades. These
items are known to break up during use and present a
high risk of serious injury to the operator or bystanders..
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or damage
to it. Any part that is damaged should be properly
repaired or replaced by an authorised service centre.
TRIMMER SAFETY WARNINGS
■ Replace string head if cracked, chipped, or damaged
in any way. Be sure the string head or blade is properly
installed and securely fastened. Failure to do so can
cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before each use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replaced by an authorised service facility.
■ Make sure the head attachment is properly installed
and securely fastened.
■ Make sure all guards, deflectors and handles are
properly and securely attached.
■ Do not modify the product in any way. This may
increase the risk of injury to yourself or others.
■ Use only the manufacturer's replacement line in the
cutting head. Do not use any other cutting attachment.
■ Never operate unit without the cutting attachment
guard in place and in good condition.
■ Maintain a firm grip on both handles while trimming.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
BRUSHCUTTER SAFETY WARNINGS
■ In addition to the above rules, these additional
instructions are appropriate when using the machine
in brush cutter mode.
■ Use heavy-duty gloves while installing or removing
blades, they have sharp edges.
■ Do not attempt to touch or stop the blade when it is
rotating.
■ A moving blade can cause severe injury. Maintain
proper control of the machine with both hands until the
blade has completely stopped rotating.
■ Replace any blade that has been damaged. Always
make sure blade is installed correctly and securely
fastened before each use.
■ Use only the manufacturer’s replacement Tri-Arc™
blade. Do not use any other cutting attachment.
■ Never cut any material over 13 mm diameter.
■ Your Brushcutter is fitted with a harness. Carefully
adjust the harness to fit comfortably and help to
support the weight of the machine at your right side.
■ Identify the Quick Release mechanism and practice
using it before you start using the machine. Its
correct use may prevent serious injury in case of
an emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.
■ Cover the blade with the blade protector before storing
the unit, or during transportation. Always remove the
blade protector before using the unit. If not removed,
the blade protector could become a thrown object as
To Next Page
Loading...
