Why Ryobi Trimmer engine does not reach full speed and emits excessive smoke?
If your Ryobi Trimmer engine does not reach full speed and emits excessive smoke, use fresh fuel and the correct 2-stroke oil mix. Also, clean the air filter. For the spark arrestor screen, contact a servicing dealer.
What to do if Ryobi RBC26SESB engine starts but will not accelerate?
If the Ryobi Trimmer engine starts but will not accelerate, allow the engine to completely warm up for approximately three minutes. If it still does not accelerate after this time, contact a servicing dealer.
What to do if Ryobi RBC26SESB engine does not stop when switch is turned off?
If the engine on your Ryobi Trimmer does not stop when the switch is turned off, set the start lever to CHOKE “ ” to stop the engine. Immediately stop using the product. Check the electrical connection on the bottom of the trimmer to ensure it is properly connected. If the problem persists, contact a servicing dealer.
Why my Ryobi Trimmer engine will not start?
If your Ryobi Trimmer engine won't start, ensure the power switch is in the ON or "I" position. If there is no spark, the spark plug may be damaged, so remove it and check for dirt and cracks, and replace it if needed. Also, make sure there is fuel by pushing the primer bulb until it is full; if it doesn't fill, the fuel delivery system may be blocked, so contact a servicing dealer. If the engine is flooded, remove the spark plug, turn the unit with the spark plug hole aimed at the ground, set the start lever to “ ” position, and pull the starter cord 10 to 15 times to clear excess fuel. Clean and reinstall the spark plug, and clean up any spilled fuel, moving at least 9m away before restarting. Pull the starter three times with the start lever at “ ”. If it doesn't start, set the start le...
Explains safety alerts, manual references, and PPE guidance symbols.
Details symbols for blades, engine speed, protective wear, fuel, and oil.
Defines the product's intended purpose and limitations for outdoor use.
Provides crucial safety precautions for operating the trimmer/brushcutter.
Lists and references parts of the string trimmer/brushcutter.
Instructions for unpacking the product and verifying included accessories.
Introduces the main assembly steps and related warnings.
Safe refueling, mixing, and engine start/stop procedures.
Techniques for holding and operating the trimmer effectively.
Guidance on cleaning air filter, replacing spark plug, and general upkeep.
Specific advice for safe and effective cutting with the blade.
To Next Page
General
