Ryobi RBC52FSBHO - Starting a Cold Engine

16
OPERATION
x10x10
1
2
44
VIVI
2
1
66
VIVI
1
2
3
30
4
STARTING A COLD ENGINE
1. Lay the product on the ground. Press the
SULPHUEXOEWLPHV
NOTE: After the 7th press, the fuel should
be visible in the primer bulb. If not, continue
pressing until the fuel is visible.
Set the choke lever to choke position.
2. 3XOO WKH VWDUWHU JULS ZLWK D TXLFN ¿UP DQG
consistent upward motion until the engine
attempts to start. Do not pull the starter grip
more than 4 times.
3. Set the choke lever to
position. Pull the
starter grip until the engine starts. Do not pull
the starter grip more than 6 times.
NOTE: If the engine does not start, repeat
the procedure again from setting the choke
lever to choke position.
4. $OORZWKHHQJLQHWRUXQIRUVHFRQGV