18
OPERATION
1
2
x10x10
1
2
2
3
1
2
1
STARTING A COLD ENGINE BY ELEC-
TRICAL STARTER
1. Install the starter bit into the electrical starter
with the pentagon bit facing outside. Push
the F/R button to the left until the pentagon
symbol shows on the F/R button.
2. Insert the battery pack into the electrical
starter until it clicks into place.
WARNING:
Keep your hands away from
the starter bit to avoid injury.
3. Lay the product on the ground and
make sure that the cutting means does
not come in contact with anything.
Press
WKHSULPHUEXOEWLPHV
NOTE
:
After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the
fuel is
visible.
Set the choke lever to
choke position.
To Next Page
Loading...
