22
English (Original instructions)
TROUBLESHOOTING
If these solutions do not solve the problem contact your authorised service dealer.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start.
No spark
Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on metal
cylinder. Pull the starter rope and watch for
spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
No fuel
Push primer bulb until bulb is full of fuel. If bulb
does not ll, primary fuel delivery sys tem is
blocked. Con tact a servicing dealer. If prim er
bulb lls, engine may be ooded, proceed to
next item.
Engine is ooded.
1. Remove spark plug, then turn the product so
the spark plug hole is aimed at the ground.
2. Set the choke lever to « B » position and
pull starter cord 10-15 times. This will clear
excessive fuel from the engine.
3. Remove any fuel from the product.
4. Clean and reinstall the spark plug.
5. Clean up any spilled fuel and move at least
9 m away before restarting.
6. Pull starter handle 3 times with the choke
lever at « B » position.
7. If the engine does not start, set the choke
lever to « B » choke position and repeat the
normal starting procedure.
8. If the engine still fails to start, repeat the
procedure using a new spark plug.
Starter rope is hard to pull. Contact a servicing dealer.
Engine starts but will not
ac cel er ate.
Engine requires approximately
three minutes to warm up.
Allow engine to completely warm up. If engine
does not accelerate after three minutes,
contact a servicing dealer.
Engine starts but will only run at
high speed at half choke.
Carburettor requires
adjustment.
Contact a servicing dealer.
Engine does not reach full speed
and emits excessive smoke.
Lubricant and fuel mixture is
incorrect.
Use fresh fuel and the correct 2-stroke
lubricant mix.
Air lter is dirty.
Clean air lter. Refer to Cleaning the Air Filter
section earlier in this manual.
Spark arrestor screen is dirty. Contact a servicing dealer.
Engine starts, runs, and
accelerates but will not idle.
Idle speed screw on carburettor
requires adjustment.
Contact a servicing dealer.
To Next Page
Loading...
