19
OPERATION
Felling a tree
5 cm / 2 in
5 cm / 2 in
1
WARNING:
handles, with both hands on the saw and
position your body and arm to allow you
to resist kickback forces. Kickback forces
can be controlled by the operator, if proper
precautions are taken. Do not let go of the
chainsaw.
WARNING: Kickback may occur when
the nose or tip of the guide bar touches
an object, or when the wood closes in and
pinches the saw chain in the cut.
WARNING: An escape path should be
planned and cleared as necessary before
cuts are started. The escape path should
extend back and diagonally to the rear of the
expected line of fall.
1. Make the felling back cut at least 5 cm. /
2 in. higher than the horizontal notching
cut. Keep the felling back cut parallel to
the horizontal notching cut. Make the
felling back cut so enough wood is left
to act as a hinge. The hinge wood keeps
the tree from twisting and falling in the
wrong direction.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
