Ryobi RCS5050 - Box Contents and Symbols; Whats in the Box; Product Symbols

9
CHAIN CATCHER
A chain catcher prevents the saw chain from being thrown
back towards the operator if the saw chain comes loose
or breaks.
WHAT’S IN THE BOX
See page 12
RCS5050
Ŷ Chainsaw x1
Ŷ Guide bar cover x1
Ŷ Combination wrench x1
Ŷ Operator’s manual x1
Ŷ Engine oil (76 ml) x1
Ŷ Chain and bar oil (76 ml) x1
SYMBOLS ON THE PRODUCT
Safety alert
To reduce the risk of injury, user must
read and understand operator’s manual
before using this product.
Regulatory Compliance Mark (RCM).
3URGXFWPHHWVDSSOLFDEOHUHJXODWRU\
requirements.
Wear eye, hearing and head protection
when operating this equipment.
Wear non-slip safety footwear when
using the product.
Wear non-slip, heavy-duty protective
gloves when handling the chainsaw.
Danger! Beware of kickback.
Hold and operate the saw properly with
both hands.
Do not operate the saw using only one
hand.
Use unleaded petrol intended for motor
vehicle use with an octane rating of 91
([R+M]/2) or higher.
Mix fuel outdoors where there are no
VSDUNVRUÀDPHV
'RQRWVPRNHZKHQPL[LQJIXHORU¿OOLQJ
fuel tank.
118
The guaranteed sound power level is
118 dB
Set the chain brake to the "run"
position.
Set the chain brake to the "brake"
position.
Fully press and release the primer bulb
at least 10 times.
3XOOWKHFKRNHOHYHUDOOWKHZD\RXWWR
the "full-choke" position.
3XOOWKHVWDUWHUJULSXQWLOWKHHQJLQH
DWWHPSWVWRVWDUWQRPRUHWKDQ¿YH
times).
3XVKWKHFKRNHOHYHUDOOWKHZD\LQWR
the run position.
3XOOVWDUWHUJULSXQWLOWKHHQJLQHVWDUWV
QRPRUHWKDQ¿YHWLPHV
Depress the trigger release and
squeeze the throttle trigger, then
release the throttle trigger to return the
engine to idle.
Allow the product to run idle for 15 - 30
seconds.
Bar and chain lubricant
SYMBOLS IN THIS MANUAL
Mix fuel outdoors where there are no
VSDUNVRUÀDPHV
'RQRWVPRNHZKHQPL[LQJIXHORU¿OOLQJ
fuel tank.
3DUWVRUDFFHVVRULHVVROGVHSDUDWHO\
Note
Warning