29
OPERATION
1
2
7
6
8
1
2
5
5. Loosen the spark plug by turning it
counterclockwise with a wrench.
6. Remove the spark plug.
7. Hand thread the new spark plug, turning
it clockwise. Tighten securely with a
wrench at
16 ~ 22 Nm (Turn a new spark
plug 180° or 3 flats past finger tight. Turn
a reused spark plug 20° or 1/3 flat past
finger tight). Do not overtighten.
NOTE: Be careful not to cross-thread
the spark plug. Cross-threading will
damage the cylinder of the product.
8. Connect the spark plug wire to the spark
plug.
To Next Page
Loading...
