Ryobi RHT25460RO - Page 13

11
1
2
3
1
2
4
3 4
1
s
1
2
11
12
1010
5 6
1
2
7
13
GETTING STARTED GETTING STARTED GETTING STARTED
Loosen the fuel cap. Remove the fuel cap. Carefully pour
fuel mixture into the tank. Avoid spillage. Immediately
replace fuel cap and hand tighten.
Remove the scabbard from the blade. Slide the
HEDGESWEEP
TM
over the blade.
Lay the product on the ground.
To start a cold engine, press the primer bulb 10 times.
Set the choke lever to
position.
After engine starts, allow the engine to run for 10
seconds.
Set the choke lever to
positioin.
CAUTION: Always use two hands to operate the hedge
trimmer which is fitted with two handles.
To operate the product, press the trigger lock
and the throttle trigger.
NOTE: To stop the engine, press the switch to
the STOP position.
<x4<x4
1
3
2
8
Press the trigger lock and throttle trigger. Pull the starter
grip until the engine starts. Do not pull the starter grip
more than 4 times.