Ryobi RHT2660RN - User Manual

Questions and Answers

T
Tammy FranklinAug 7, 2025
What to do if Ryobi RHT2660RN engine does not reach full speed and emits excessive smoke?
- V
  Vincent JordanAug 7, 2025
  If your Ryobi Trimmer engine isn't reaching full speed and is emitting excessive smoke, it could be due to: * Incorrect lubricant fuel mixture. Use fresh fuel and the correct 2-stroke lubricant mix. * A dirty air filter. Clean the air filter. * A dirty spark arrestor screen. In this case, contact a servicing dealer.
S
Selena BrownAug 14, 2025
Why Ryobi RHT2660RN engine starts but will not accelerate?
- D
  dmurphyAug 14, 2025
  If your Ryobi Trimmer engine starts but won't accelerate, it might be because the engine requires about three minutes to warm up. Allow the engine to completely warm up. If it still doesn't accelerate after three minutes, contact a servicing dealer.
P
Paula MartinezAug 20, 2025
What to do if Ryobi Trimmer engine starts, runs, and accelerates but will not idle?
- A
  Aaron AguilarAug 20, 2025
  If the Ryobi Trimmer engine starts, runs, and accelerates but will not idle, the idle speed screw on the carburetor may need adjustment. Contact a servicing dealer.
P
paul75Aug 26, 2025
How to fix Ryobi RHT2660RN engine that starts but will only run at high speed at half choke?
- R
  Roy JenningsAug 26, 2025
  If your Ryobi Trimmer engine starts but will only run at high speed at half choke, the carburetor likely requires adjustment. Contact a servicing dealer.
B
brandonmartinezNov 1, 2025
Why Ryobi RHT2660RN engine will not start?
- J
  johnwilliamsNov 1, 2025
  The Ryobi Trimmer engine might not start due to several reasons: * There's no fuel. Try pushing the primer bulb until it fills with fuel. If it doesn't fill, the primary fuel delivery system may be blocked, so contact a servicing dealer. If the primer bulb fills, the engine might be flooded. * The engine is flooded. Pull the starter with the choke lever at the “Run” position and wide open throttle. If it doesn't start, move the choke lever to “Full” and repeat the normal starting procedure. If it still fails, repeat the procedure with a new spark plug. * There's no spark. Check for a spark by removing the spark plug, reattaching the cap, and laying the plug on the metal cylinder. Pull the starter rope and watch for a spark at the plug tip. If there's no spark, repeat the test with a...