1
2
3
4
5
7
5
4
6
4. Hold and squeeze the rear handle,
throttle trigger, and throttle trigger lock.
Use your right hand to put the starter
bit shaft to the shaft hole on the
engine. Make sure the starter bit is
properly engaged. Press and hold the
electrical starter switch button until the
engine attempts to start. Do not press
the electrical starter for more than 4
seconds.
5. Set the choke lever to
position.
Press the trigger lock and the throttle
trigger.
Put the starter bit shaft to the shaft
hole on the engine. Press and hold the
electrical starter switch button until the
engine attempt to start. Do not press
the electrical starter for more than 4
seconds.
6. Allow the engine to warm up for 10
seconds prior to operation.
Set the choke lever to
position.
7. Press the throttle trigger and throttle
trigger lock.
To Next Page
