Ryobi RLM36B46S1 User Manual

1
3
2
1
3
2
1
2
1
2
7a
Wear full eye protection, ear protection, non-slip heavy-
duty gloves, substantial footwear, and long trousers at
all times while operating the product. Do not operate the
product when barefoot or wearing open sandals.
Align the handle with the brackets using the quick-release
fasteners as reference. Insert the bolt through the hole
located on the lower half of the handle, then add a
washer. Ensure that the washer is between the handle
and the bracket. Tighten the bolt to secure the handle
using the T40 wrench.
Raise the rear door. Install the mulching plug, ensuring
that it is secured and locked into place. Lower the rear
door.
NOTE: The mulching plug covers the rear discharge
opening, which allows the blade to cut and recut for ner
clipppings.
Mulching
3 4
1
2
7b
1
2
1
2
8 9
5
STOP
GO
B
1
A
2
2
A
+
or
B
1
2
4
3
5
6
NOTE: Make sure that the handle is fully extended
so that the handle locks can properly secure the
handle.
Open the handle locks to unlock the handle. Fully extend the handle.
Close the handle locks to secure the handle.
Raise the rear door. Install the grass catcher, hooking it to
the mower. Ensure that the catcher is secured, then lower
the rear door.
NOTE: The grass catcher collects grass clippings
preventing them from being discharged across the lawn.
10
Adjust the operating angle of the handles according to preference. On each side of the handle, pull the quick-release
fastener, and turn it 90°. Align the fastener to the locking slot that provides the preferred handle height. Turn the quick-
release knob 90°, and push the fastener into the locking slot. Make sure that the fastener is fully inserted into the slot
and that the handle is properly secured.
Open the battery door, and insert the battery pack. Make
sure that the latch in the battery snaps in place and that
the battery pack is secured before operating the product.
Insert the isolator key, then close the battery door.
NOTE: The product does not start without the isolator key.
Ensure that the isolator key is inserted into the product.
To start the mower, press the start button and squeeze
either side of the on/off lever.
NOTE: The on/off lever must be continuously held during
use. To turn off the product release the on/off lever.
Catching
11
GETTING STARTED GETTING STARTED GETTING STARTEDGETTING STARTED

Ryobi RLM36B46S1 Specifications

General

Brand	Ryobi
Model	RLM36B46S1
Category	Lawn Mower
Language	English