Ryobi RLM46175SL - Troubleshooting

English
12
TROUBLESHOOTING
Problem Possible cause Solution
The handle is not in
the correct position.
The handle is positioned incorrectly. Check and ensure that the lower part of handle is pushed
fully back and snapped into proper position.
The handle knobs are not tightened. Tighten the handle knobs..
The mower does
not start.
There is no petrol. Fill the mower with petrol. If the mower still does not start,
contact an authorised service centre..
The engine is 
ooded. Wait for 15 minutes, then try starting the mower again. Do
not prime before attempting to start.
The starter rope is harder to pull now
than when it was new.
Contact an authorised service centre.
The mower is hard
to push.
The grass to be mowed is too tall.
The mower housing and blade is being
dragged through heavy grass.
The cutting height is too low.
Raise the cutting height.
The wheel assembly needs cleaning. Clean the wheel assembly. See the Drive Gear
Maintenance section.
The mower is
vibrating at a higher
speed.
The blade is unbalanced. Replace the blade.
The motor shaft is bent. Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Inspect for damage. Have
the damage repaired by an authorised service centre
before restarting the product.
The grass catcher
is not being filled
up with grass even
though grass is
being cut from the
lawn.
The discharge chute is blocked. Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Remove grass catcher
and lift discharge chute cover. Beware of the sharp blade
and avoid contact. Remove the debris from the discharge
chute.