English
4
Carefully pour petrol into the tank.
Push the primer bulb 3 times.
Hold the power lever down against the
handle.
Pull the starter cord until the engine
runs.
Mow across the surface of the slope.
Avoid mowing up and down.
Remove objects that could be thrown by
the rotating blade.
Keep bystanders a safe distance away
from the product.
Fuel and its vapours are explosive and
can cause severe burns or death.
Fuel and its vapors are extremely
fl ammable and explosive. Fire can
cause severe burns or death.
Use unleaded petrol intended for motor
vehicle use with an octane rating of 87
[(R + M)/2] or higher.
Use SAE 30 or 10W-30 API-SJ weight
oil.
Conforms to all regulatory standards in
the country in the EU where the product
is purchased.
EurAsian Conformity Mark
Ukrainian mark of conformity
Hold the power lever down against the
handle to keep the engine running.
Release the power lever to stop the
product.
96
Guaranteed sound power level is 96 dB.
Stop the product.
Open and close the fuel valve
Remove the ONE+
TM
EasyStart
TM
key
when the product is not in use.
Close the battery cover.
Snap the cover in place.
RAC400
Replacement blade part number.
SYMBOL(S) ON THE BATTERY
Do not dispose of used battery packs
in the household refuse or by burning
them. Hand them over to applicable
collection points.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
Injury caused by vibration. Always use the right tool for
the job, use designated handles, and restrict working
time and exposure.
Hearing injury caused by exposure to noise. Wear
hearing protection and limit exposure
Injury caused by contact with the blades
Injury caused by thrown objects
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud’s Syndrome.
Symptoms may include tingling, numbness, and blanching
of the fi ngers, usually apparent upon exposure to cold.
Hereditary factors, exposure to cold and dampness, diet,
smoking, and work practices are all thought to contribute to
the development of these symptoms. There are measures
that can be taken by the operator to possibly reduce the
effects of vibration:
Keep your body warm in cold weather. When operating
the product, wear gloves to keep the hands and wrists
warm.
After each period of operation, exercise to increase
To Next Page
Loading...
