Ryobi RLT-710 - Operation and Maintenance; Starting, Stopping, and Trimming; Edging and Line Spool Replacement

11
OPERATION
CAUTION: Always wear eye protection.
STARTING AND STOPPING (Fig. 22)
1. Squeeze the trigger switch (2) to start the trimmer.
2. Release the trigger switch to stop the trimmer. (Fig. 22)
TRIMMING
1. Use the trimmer at an angle of approximately 15-degree to the working area (Fig.23).
2. Slowly swing the trimmer from side to side(Fig.24).
3. Do not overload your trimmer, take small “bites” this will keep machine operating at high speed and will greatly
improve cutting efficiency, (Fig.25).
4. Cutting close to a wall
Use the edge guide when cutting close to an edge.
EDGING
Adjust the trimmer head angle when trimming on edges and clamp the edge guide in its upper position. Avoid
bringing the cutting device into contact with hard objects such as walls and curbstones. Push the product for-
wards using the wheel (Fig. 26).
Fig. 23 Fig. 25
Fig. 24
2
Fig. 22
Fig. 26