3
ENGLISH (Original Instructions)
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to operate the product better and safer.
SYMBOL NAME EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watt Power
min Minutes Time
~
Alternating Current Type of current
Direct current Type or a characteristic of current
n
o
No load speed Rotational speed, at no load
.../min Per minute Revolutions, strokes, surface speed, orbits etc., per minute
Safety alert Precautions that involve your safety.
Read the Operator’s
Manual
Read and understand all instructions before operating the product, follow all
warnings and safety instructions.
Regulatory Compliance Mark (RCM). This product meets applicable regulatory
requirements.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice.
Class II tool Double-insulated construction
Wet conditions alert Do not expose to rain or use in damp locations.
Indoor use only
Fuse-link
DC wire
Charging
Evaluating
Wear eye and hearing
Protection
Wear eye protection which is marked to comply with BS EN166 or Australian
and New Zealand Standards, as well as hearing protection, when operating
this equipment.
To Next Page
