10
To avoid kickback, binding of the saw bar, and possible
injury, never cut limbs that the pruner does not reach
when supported by the shoulder strap.
You may use this product for the purposes listed below:
■ Limbing
■ Pruning
Always handle fuel with care, it is highly ammable.
■ Always refuel outdoors where there are no sparks and
flames. Do not inhale fuel vapors.
■ Do not let petrol or oil come in contact with your skin.
■ Keep petrol and oil away from the eyes. If petrol
or oil comes in contact with the eyes, wash them
immediately with clean water. If irritation is still present,
see a doctor immediately.
■ Clean up spilled petrol immediately.
■ This product is powered by a 2-stroke engine and
requires pre-mixing petrol and 2-stroke oil. Pre-mix
unleaded petrol and 2-stroke engine oil in a clean
container approved for petrol.
■ This engine is certified to operate on unleaded petrol
intended for automotive use with an octane rating of
87 ([R + M] / 2) or higher.
■ Do not use any type of pre-mixed petrol / oil from fuel
service stations, this includes the pre-mixed petrol / oil
intended for use in mopeds, motorcycles, etc.
■ Avoid the use of Ethanol fuels or fuels containing
Ethanol. The use of Ethanol fuels may result in
damage to your engine.
■ Use synthetic 2-stroke oil only. Do not use automotive
oil or 2-stroke outboard oil.
■ Mix 2% synthetic 2-stroke oil into the petrol. This is a
50:1 ratio.
■ Mix the fuel thoroughly and also each time before
fueling.
■ Mix in small quantities. Do not mix quantities larger
than usable in a 30 day period. Synthetic 2-stroke oil
containing a fuel stabilizer is recommended.
■ Clean surface around fuel cap to prevent
contamination.
■ Loosen fuel cap slowly to release pressure and to
keep fuel from escaping around the cap.
■ Carefully pour fuel mixture into the tank. Avoid spillage.
■ Prior to replacing the fuel cap, clean and inspect the
gasket.
■ Immediately replace fuel cap and hand tighten. Wipe
up any fuel spillage. Move 9 m away from refuelling
site before starting engine.
It is normal for smoke to be emitted from a new
engine during and after rst use.
Always shut off engine before fueling. Never add fuel to
a machine with a running or hot engine. Move at least
9 m from refuelling site before starting engine. Do not
smoke!
1 litre + 20 ml =
2 litres + 40 ml =
3 litres + 60 ml = 50: 1 (2%)
4 litres + 80 ml =
5 litres + 100 ml =
The product may throw objects during operation,
causing injury to the operator or to bystanders. Always
wear suitable eye protection, long heavy pants and
boots while operating the product.
■ Wear non-slip gloves for maximum grip and protection.
■ Maintain a proper grip on the unit whenever the engine
is running. Use your right hand to firmly grip the rear
handle while your left hand has a firm grip on the front
handle.
■ Hold unit firmly with both hands. Always keep your left
hand on the front handle and your right hand on the
rear handle, so your body is to the left of the chain
line. Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across the
RPPGM_SAA_MAN_ENG_20110215_D8.indd 10 15/02/2011 11:38 AM
To Next Page
