To Next PageTo Next PageWhat to do if my Ryobi RTS10 does not start?
If your Ryobi Saw doesn't start, first ensure the motor cord or wall cord is properly plugged in. If it still fails to start, check the circuit fuse and replace it if blown. Also, verify that the circuit breaker hasn't tripped; if it has, reset it. If none of these steps work, the cord or switch may be damaged and require replacement by an authorized service center.
Why is my Ryobi RTS10 vibrating so much?
Excessive vibration in your Ryobi Saw can be due to several factors. The blade might be out of balance, damaged, or warped, in which case you should replace the blade. Ensure the saw is securely mounted by tightening all hardware. Also, check that the work surface is even; if not, reposition the saw on a flat surface.
What to do if my Ryobi RTS10 cutting binds or burns work?
If your Ryobi Saw is binding or burning the wood, the blade may be dull, requiring replacement or sharpening. Ensure you slow the feed rate. Also, check if the rip fence is misaligned and align it if necessary. If the wood is warped, replace it. Cutting with convex side to table surface.
Why does my Ryobi RTS10 blade makes poor cuts?
Poor cuts from your Ryobi Saw can result from a dull or dirty blade; clean, sharpen, or replace it. Ensure the blade is the correct type for the cut you're making and replace it if necessary. Also, check if the blade is mounted backwards and remount it correctly.
How to fix Ryobi Saw rip fence that does not move smoothly?
If the rip fence on your Ryobi Saw isn't moving smoothly, it may not be mounted correctly, so remount it. The rails might be dirty or sticky, requiring you to clean and wax them. Additionally, the clamp screw could be out of adjustment; adjust it counterclockwise.
How to make Ryobi Saw cut accurate 90 degrees?
If your Ryobi Saw isn't making accurate 90-degree cuts, the positive stops inside the cabinet may need adjusting for bevel cuts. For miter cuts, the miter gauge might be misaligned, so adjust the miter gauge.
Why is the height/bevel adjusting hand-wheel on my Ryobi RTS10 hard to turn?
If the height/bevel adjusting hand-wheel on your Ryobi Saw is hard to turn, the gears or screw post inside the cabinet might be clogged with saw dust. Clean the gears or screw post to resolve this issue.
Why wood edges away from rip fence when ripping with Ryobi RTS10 Saw?
If wood edges away from the rip fence when ripping with your Ryobi Saw, the blade may not be properly sharpened or set. Resharpen or set the blade to correct this issue.
Why does my Ryobi RTS10 motor labors in rip cut?
If the motor labors in a rip cut with your Ryobi Saw, the blade may not be proper for a rip cut. Change the blade; a rip blade typically has fewer teeth.
What to do if Ryobi RTS10 blade does not lower when turning height/bevel adjusting handwheel?
If the blade does not lower when turning the height/bevel adjusting handwheel on your Ryobi Saw, the locking lever may not be at the full left position. Move the locking lever to the left.
General| Type | Table Saw |
|---|---|
| No Load Speed | 5000 RPM |
| Blade Diameter | 10 in |
| Max Cut Depth at 45 Degrees | 2-1/4 in |
| Arbor Size | 5/8 in |
| Blade Diameter (mm) | 254 mm |
| Max Cutting Depth at 45° (mm) | 57 |
| Power Source | Electric |
