To Next PageTo Next PageWhy is my Ryobi RY40109 not starting?
If your Ryobi Lawn Mower isn't starting, the battery might be low, the start key might not be installed, or the handle assembly might not be in the operating position. Charge the battery, install the start key, and raise the lower and upper handle.
How to fix Ryobi Lawn Mower cutting grass unevenly?
If your Ryobi Lawn Mower is cutting grass unevenly, the lawn may be rough, or the cutting height may not be set properly. Adjust the cutting height.
Why does my Ryobi Lawn Mower motor stop while cutting?
The motor of your Ryobi Lawn Mower might stop while cutting if the cutting height is set too low. Try raising the cutting height.
What to do if Ryobi RY40109 Lawn Mower is not bagging properly?
If your Ryobi Lawn Mower is not bagging properly, the cutting height might be set too low. Raise the cutting height.
What to do if Ryobi RY40109 is not mulching properly?
If your Ryobi Lawn Mower is not mulching properly, wet grass clippings might be sticking to the underside of the deck. Wait until the grass dries before mowing.
Why is my Ryobi RY40109 vibrating at a higher speed?
If your Ryobi Lawn Mower vibrates at high speed, the blade may be unbalanced, excessively or unevenly worn, or the motor shaft could be bent. Replace the blade. Stop the motor, remove the start key and battery. Inspect for damage and have it repaired by an authorized service center before restarting.
What to do if Ryobi RY40109 Lawn Mower is hard to push?
If your Ryobi Lawn Mower is hard to push, it could be due to high grass, the rear of the mower housing and blade dragging in heavy grass, or the cutting height being too low. Raise the cutting height.
General| Brand | Ryobi |
|---|---|
| Model | RY40109 |
| Category | Lawn Mower |
| Language | English |
Understand product and manual for safe use.
Covers battery cover and storage compartment.
Covers cruise control, grass catcher, and height adjustment.
Remove product and check items.
Steps to unfold and adjust the mower's handle assembly.
Attaching grass catcher or mulching plug.
Adjusting the cutting height of the mower blade.
Lists the intended uses of the product.
Steps for installing and removing the battery pack.
Procedures for starting and stopping the lawn mower motor.
Routine cleaning and checks for the lawn mower.
Information on product lubrication requirements.
Step-by-step guide for replacing the mower blade.
