6 — English
SYMBOLS
Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpreta-
tion of these symbols will allow you to operate the tool better and safer.
SYMBOL NAME DESIGNATION/EXPLANATION
Proper Loading
Only place dry logs flat and lengthwise in the direction of the grain
on the work table. Only attempt to split one log at a time.
Improper Loading
Never attempt to split a wet log or a log that is not placed flat
and lengthwise on the worktable. Neither end should be off of
the work table on the ram or wedge. Never attempt to split more
than one log at a time.
Improper Log Type
Only split dry, cylindrically shaped logs that are cut squarely on
each end. Never attempt to split wet logs or logs that are curved
or are cut at angles on either end.
Operator Zone/Correct
Operating Position
Always be positioned in the right rear area as facing the log split-
ter controls.
Incorrect Operating Position Never stand or kneel directly behind the ram when operating.
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
Alternating Current Type of current
Class II Construction Double-insulated construction
To Next Page
Loading...
