13 — English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handle not in position. Handle adjustment pins are not in place. Pull up handle adjustment lever, release,
and make sure handle adjustment pins
lock into place.
Mower not starting. Battery is low in charge.
Quick connect plug not conneted to
the battery.
Start key not installed.
Handle assembly is not in operating
position.
Battery not connected.
Charge the battery.
Connect the battery’s quick connect
plug.
Install start key.
Raise handle to operating posistion.
Mower cutting grass unevenly. Lawn is rough or cutting height not set
properly.
Adjust the cutting height.
Mower not mulching properly. Wet grass clippings sticking to the un-
derside of the deck.
Wait until the grass dries before mowing.
Mower hard to push. High grass, rear of mower housing and
blade dragging in heavy grass, or cutting
height too low.
Raise cutting height.
Mower not bagging properly. Cutting height set too low.
Grass blocking rear chute of mower.
Raise cutting height.
Stop the motor, remove start key, and
disconnect the battery pack’s quick
connect plug. Remove grass catcher
bag and remove the blockage.
Mower vibrating at higher speed. Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Replace the blade.
Stop the motor, remove start key, and
battery. Inspect for damage. Have re-
paired by an authorized service center
before restarting.
Motor stops while cutting. Cutting height set too low. Raise the cutting height.
This product has a Five-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
or call (toll free) 1-800-525-2579.
To Next Page
Loading...
