Rytan RY256 - Page 4

4
M)
Maintain a sharp cutter wheel. A dull cutter wheel is not only inefficient but also dangerous. A du
ll
cutter wheel can produce excessive cutting force on a key blank and exceed the machine’s vise jaws
cl
amping force to a point where the key blank could be ripped out of the machin
e.
N)
Disconnect machine. When not in use, during servicing, or when
changing cutter wheel and accessory
Brush always disconnects th
e m
achine from
its electrical power source.
O)
Remove servicing wrenches. Remove all service tools from the machine before turning it
on.
P)
Always turn off machine. After cutting a key, turn off the machine before removing a cut key
and
cl
amping another fresh bl
ank.
Q)
Always lock carriage back. After cutting a key, turn off the machine and lo
ck the carriage back to
prevent accident or injury.
R
)
Out
doors use. When machine is used outdoors, use only extension cords suitable for outdoors and that
have a built-in third wire and ground terminal. NEVER CUT OFF THE GROUND TERMINAL
FROM THE MACHINE’S POWER PLUG!
R)
Keep hands away from the cutter and key blank. Keep hands away from
rotating cutter. Do not reach
underneat
h or around cutter or key blank when cutter is rotating. Do not attempt to remove key bl
ank
o
r key blank material while cutter is rotating.
S)
Never use machine in an explosive atmosphere. For example, if your machine is in a service van with
a
fu
el leak or spill, switching on the machine could ignite the fume
s.
NOTE: A FLAMMABLE SOLVENT SPILL IN YOUR SHOP OR VAN IS EQUALLY
DANGEROUS!
T)
Inspect machine cord periodically. If damaged, repair at
once.
U)
Keep hands dry, clean and free from
oil and grease.
V)
Stay alert. Watch what you are doing and use common sense. Do not operate m
achine when you are
tired.
W
)
Do not use m
achine if switch does not turn the machine ON and
OFF.
X) Drugs, Alcohol, Medication. Do not
operate machine while under the influence of drugs, alcohol
, or
any m
e
dication
Y)
The operation of any key machine can result in foreign objects being thrown into the eyes, which can
result in severe eye damage. Always wear safety glasses or eye shields before commencing key
machine operation. We recommend wide vision safety mask for use over spectacles or standard safety
glasses.
Z)
Save these instructions
.