s::can con::cube D-315 - Starting up of Operation Software; Con::cube Sleep Mode

Furthermore the cable terminals 10 (+ DC In) and 9 (- DC In) provide the possibility to connect an external battery for
back-up power supply (UPS) in case the main power supply is interrupted. Please consider the following limitations
whenusingthisspecicpowersupplyinput:
The power supply of the battery has to be 12 - 15 VDC when connected via cable terminals 10 and 9.
 Onlybatteriesthatenabletotaldischargeorthatareequippedwithautomaticalswitcho󰀨mustbeused.
This battery supply input provides only protection against inverse polarity and short circuit.
This battery supply input provides no galvanic isolation and no protection against ligthning.
If in addition to battery also solar panels with charge controllers are used, a DC/DC stabiliser has to be installed in any
case to intercept possible voltage peaks. Otherwise the connected probes might be damaged.
5.6 Starting up of Operation Software
Once the con::cube is connected to the power supply (see section 5.5), it will show the s::can
logo for a few seconds while starting up. During the startup of moni::tool a message as shown
on the right hand side is visible. Please consider that the complete start up procedure will
require appox. 1 - 2 minutes.
When no probes and sensors have been installed yet (initial
startup), only the main window and the menu tabs are visible
on the display.
Please refer to the manual of the operation software moni::tool
for all further tasks to complete the initialisation of your s::can
monitoring system.
5.7 con::cube Sleep Mode
Foroperationwithlowpowerconsumptionaspecicsleepmodecanbeconguredonthecon::cubeviamoni::tool
(Service \ Terminal \ con::cube \ Power Save).
When using the sleep mode in combination with a 3G modem, the most actual moni::tool version V3.1.4 has to be used. When
usinganolderversion,amodicationofajumperisneeded(informationnotehowtodothisisavailablevias::cancustomer
support).
con::cube D-315, 01-2020 Release Copyright © s::can Messtechnik GmbH
www.s-can.at16 / 42
!
!
!