Saba GCO-613 - Troubleshooting and Wiring; Troubleshooting Guide; Wiring Diagram

Trouble shooting
Problem
Possible cause
Solution
No Heat
Igniter defective
Call authorized Service center
No Heat
Power switch on control panel is off
Set the control panel to COOK
No Heat
Doors are open
Close doors
No Heat
Door micro switch defective
Call authorized service center
No Heat
Gas valve to oven may be in the cleared position
Turn gas valve on
Oven has not reached proper
The oven has not reached
Wait for oven to reach pre-heat
temperature
pre-heat temperature
temperature
Oven has not reached proper
Internal problem with main
Call authorized service center
temperature
temperature control
Convection fan does not run
Oven has no electrical power
Check electrical supply
Convection fan does not run
Circuit breaker tripped
Reset the breaker
Convection fan does not run
Doors are open
Close doors
Convection fan does not run
Door Micro-switch defective
Call authorized service center
Food Browns unevenly
Improper heating temperature
Pre-heat until desired temperature is reached
Food Browns unevenly
Baking pan dark or glass
Lower oven temp by 25°F
Food dries before browning
Oven temp too high
Lower oven temp
Food dries before browning
Oven door opened too much
Stop opening oven door so much
Oven cycles 3 times and locks itself out
Flame sensor defective
Call authorized service center
Wiring diagram
Gas igniter
Flame sensor
IC2 Gas controller
YV Combination valve